Montres Outlet

How do you change a watch strap? The video guide

The video guide · 2:27

Chapters

  1. 0:00One part to know
  2. 0:13The spring bar
  3. 0:30Measuring between the lugs
  4. 0:53The watchmaker's fork
  5. 1:11Drilled lugs
  6. 1:22Fitting it and pulling
  7. 1:49Quick-release bars
  8. 2:05Two precautions

Transcript

A new strap, and it is a different watch. Changing it yourself takes a few minutes, as long as you know one single part: the spring bar. It is a small steel rod, slipped through the end of the strap. Inside, a spring pushes both its ends into small holes on the inside of the lugs. To free the strap, you only need to compress that spring. Before you buy, only one measurement matters: the inside gap between the lugs, where the spring bar sits. That is the exact width of the strap, often twenty or twenty-two millimetres. One millimetre less, and it wobbles. One more, and it will not fit. The tool: a small watchmaker's fork. Slide it between the strap and the lug, catch the shoulder of the spring bar, and push towards the centre. The bar leaves its hole, and the strap comes free. If the lugs are drilled right through, it is simpler: you push the bar from the outside, with the pointed end of the tool. To fit the strap, the reverse: one end in its hole, compress the other, guide it in, let go. Then give the strap a firm tug. The dive watch standard requires each attachment to hold two hundred newtons, the weight of about twenty kilos. A badly seated spring bar gives way without warning. And with no tool at all? Quick-release spring bars. A small lever sticks out under the strap: pull it with your fingernail, and the strap comes free. Many replacement straps have them. Two precautions. A piece of tape on the lugs: the fork slips easily, and scratches steel. And a bent spring bar cannot be straightened: replace it, with one of the right length. Discover a whole selection of watches at Montres Outlet.

More video guides